Free 2014 Apple 9L0-010 Dump(1-10) Download!

You are preparing to replace faulty RAM inside a Mac mini (Mid 2010). What should be used to open the bottom cover?

A.    Putty knife
B.    Philips #00 screwdriver
C.    Mac mini (Mid 2010) Logic Board Removal Tool
D.    Your hands, no tools are required for this procedure

Answer: D

Which of the following measurements is an example of an appropriate use of a multimeter when troubleshooting a Mac?

A.    Measure logic board battery voltage.
B.    Measure high voltage going to a CRT.
C.    Measure AC current going to an optical drive.
D.    Measure digital signals on the main processor.

Answer: A

You require additional information about a specific problem with a customer’s Mac. Which one of the following resources is the Apple-recommended choice for researching the problem?

A.    Downloads
B.    Discussions
C.    User’s manual
D.    Apple support articles

Answer: D

Which section of any Apple Technician Guide is the BEST place to look for instructions for replacing an internal component?

A.    Views
B.    Basics
C.    Take Apart
D.    Troubleshooting

Answer: C

According to Apple Technician Guides, what should be completed before performing any take- apart steps when replacing a part in any Apple product?

A.    Disconnect and reconnect all internal cables.
B.    Lay the product on its side so it will not fall over.
C.    Discharge the CRT and establish an ongoing ground.
D.    Gather all necessary tools and perform all preliminary steps.
E.    Order all available service parts for the appropriate configuration of the product.

Answer: D

Which TWO details are derived from entering an Apple product’s serial number into the Online Service Assistant section of the Apple Support web page? SELECT TWO

A.    Mac OS version
B.    Warranty status
C.    AppleCare name
D.    Installed memory
E.    Number of USB ports

Answer: BC

A customer asks about RAM speed requirements to upgrade his Mac. To which Apple support site resource should you refer this customer?

A.    Downloads
B.    Discussions
C.    Specifications
D.    Technician Guide

Answer: C

What component of a Mac mini (Early 2009) logic board requires use of an anti-static foam support to avoid damage?

A.    EMI clips
B.    Video card
C.    Large heat sink
D.    Battery connector

Answer: A

Which of the following is a valid precaution you should take when you begin working inside a MacBook Pro (13-inch, Mid 2010)?

A.    Reset the SMC.
B.    Remove the hard drive.
C.    Disconnect the optical drive.
D.    Disconnect the main battery.

Answer: D

Which of the following is a valid precaution you should take while working inside an iMac (27-inch, Mid 2010) system that is plugged into AC power but has not yet been powered on?

A.    Do not turn the unit upside-down.
B.    Avoid putting your fingers near the fans.
C.    Make sure you are NOT wearing a grounded ESD wrist strap.
D.    Do not touch the processor heat sink because it could burn your fingers.

Answer: C

If you want to pass the Apple 9L0-010 Exam sucessfully, recommend to read latest Apple 9L0-010 Dump full version.


Comments are closed.