[2017-New-Version]Exam 400-201 Dumps PDF and VCE 627q Free Offered by Braindump2go[143-155]
2017 May New: Cisco 400-201 Exam Dumps with VCE and PDF Free Updated in www.Braindump2go.com Today!
100% Real Exam Questions! 100% Exam Pass Guaranteed!
1.|2017 Version New 400-201 Exam Dumps (PDF & VCE) 627Q&As Download:
2.|2017 Version New 400-201 Exam Questions & Answers Download:
Customers connecting to a Service Provider for Internet access are intending to implement redundant peering. The design requirements call for preferring a primary link for both ingress and egress traffic. Secondary links should be used only during primary outages. What two BGP deployment options will accomplish this design goal? (Choose two.)
A. On the router handling the secondary link, advertise routes with a MED value of 0.
B. On the router handling the primary link, set the weight for all incoming routes to be a value of 0.
C. On the router handling the secondary link, advertise all routes with a longer AS-PATH value.
D. On the router handling the primary link, advertise all routes with a longer AS-PATH value.
E. On the router handling the secondary link, set the local preference for all incoming routes to be a value of 0.
Refer to the exhibit. R1 and R2 are multicast routers running PIM over Serial1/0.
The PIM adjacency on R1 is not forming with the given configuration.
What command can be entered on R1 to resolve the issue?
A. no access-list 100 deny 103 any any
B. no access-list 100 deny udp any any eq 103
C. no access-list 100 deny ip any host 220.127.116.11
D. no access-list 100 deny ip any host 18.104.22.168
All PIM protocols share a common control message format. PIM control messages are sent as raw IP datagrams (protocol number 103), either multicast to the link-local ALL PIM ROUTERS multicast group, or unicast to a specific destination. Reference: http://www.metaswitch.com/resources/what-is-protocol-independent-multicast-pim
There are two cabling schemes to choose from when implementing a Cisco CRS-1 multi shelf system: single module cabling and multi module cabling.
What is the maximum capacity of the LCCs that are supported in multi module cabling?
A. 9 LCCs
B. 7 LCCs
C. 10 LCCs
D. 6 LCCs
E. 8 LCCs
Which statement about MPLS TE Fast Reroute (FRR) node protection operation is not correct?
A. It requires a next-next hop backup tunnel.
B. Point of local repair (PLR) swaps the next hop label and pushes the backup label.
C. The backup tunnel terminates on the merge point (MP) where traffic rejoins the primary tunnel.
D. The backup tunnel can have associated bandwidth capacity.
E. Restoration time is expected under 50 ms.
Regarding to EIGRP protocol, a “successor” is:
A. A neighbor that has met the feasibility condition
B. A neighbor that has met the feasibility condition and has the lowest cost path towards the destination
C. Any neighbor that is in the path towards the destination.
D. Any neighbor that is in the path towards the destination and whose reported distance equals the feasible distance.
Which three statements about MPLS Label Distribution Protocol (LDP) are valid?
A. LDP hello packets are sent to UDP port 646
B. LDP hello packets are sent to TCP port 711
C. LDP sessions are TCP sessions to port 646
D. LDP sessions are TCP sessions to port 711
E. LDP establishes a peer relationship with another router that must be directly attached.
F. LDP can establishes a peer relationship with another router that is not directly attached
Select two valid administratively scoped multicast addresses in networks running Interior Gateway protocols like EIGRP and OSPF (Choose two).
A network engineer is designing the BGP architecture with a requirement of preventing the AS from becoming a Transit AS path, using the following configuration:
router bgp 65000
neighbor 10.0.0.1 route-map BGP-ROUTE-POLICY in
The goal is to prevent routes learned from 10.0.0.1 from being advertised to any other eBGP peering in the AS 65000.
What command should be used within the route map to achieve this goal while keeping existing route policies in place?
A. set community no-export additive
B. set community no-advertise
C. set community no-advertise additive
D. set community no-export
Setting no-advertise will block the route from being advertised to anywhere anywhere, question says it wants to prevent the AS from becoming transit, therefore no-export will stop any eBGP router advertising outbound and therefore stop transit.
A service provider is implementing Ethernet solutions for clients that are not being provisioned within the MPLS core network.
Which solution allows the Service Provider to complete Ethernet circuit provisioning in this scenario?
L2TPv3 defines the L2TP protocol fortunnelingLayer 2 payloads over an IP core network using Layer 2 virtual private networks (VPNs). Benefits of this feature include the following:
– Simplifies deployment of VPNs.
– Does not require Multiprotocol Label Switching (MPLS) virtual private network (VPN).
– Supports Layer 2tunnelingover IP for any payload.
– Supports data encapsulation directly over IP (IP protocol number 115), not using User Datagram Protocol (UDP)
– Supports point-to-point sessions, not point-to-multipoint or multipoint-to-point sessions
– Supports sessions between the same Layer 2 protocols, for example Frame Relay-to-Frame Relay or ATM-to-ATM.
Which is the main characteristic of LTE architecture comparing to other mobile architectures?
A. Provides supports to deploy Layer 3 MPLS VPN model, where other mobile architectures do not support.
B. Offers node redundancy with the static route configured on the IP NodeB using the HSRP/VRRP virtual ip address.
C. Provides a simpler, less hierarchical model with the capability of simplistically distributing the core gateways.
D. Introduces a hierarchical model with connection-oriented service requirements and one- to-one relationships.
If two routers, both reachable from one another, originate functionally equivalent type 2 external LSAs (i.e. same destination, cost and non-zero forwarding address). Which of the following statements would apply?
A. Only the LSA generated by the lowest RID ASBR will exist in the network
B. Two LSAs will exist in the network for this destination, but only the one generated by the highest RID ASBR will be used
C. Two LSAs will exist in the network for this destination, and both will be used
D. Only the LSA generated by the highest RID ASBR will exist in the network
When troubleshooting a DoS attack, a support engineer finds a huge number of packets that are destined to one of the core routers interface IP address. By the time the packets reach this core router, they have a TTL of 0. Based on Cisco platform running IOS 15.3S, which technique is most effective in resolving this problem?
A. Configure LPTS.
B. Configure an ACL on the core router interface.
C. Configure CoPP on the core router.
D. Configure policing on PE routers.
E. Configure a receive ACL on the core router.
Routes redistributed into an OSPF ASBR are which LSA type?
A. LSA type 6
B. LSA type 1
C. LSA type 2
D. LSA type 5
E. LSA type 3
F. LSA type 4
1.|2017 Version New 400-201 Exam Dumps (PDF & VCE) 627Q&As Download:
2.|2017 Version New 400-201 Study Guide Video: